ayerbe 587300 Manual De Instrucciones página 27

Changing The Battery – Replace Only With A 23AE 12V Alkaline Battery
1. Take a Phillips screwdriver and remove the screws on the remote control. (fig. 1)
2. Slide back the remote cover so that the white triangle on the remote cover points to the unlock symbol
" " . (fig. 2 & 3)
3. Remove the remote cover from the handle. (fig. 4)
4. Lift the foam cover to expose the battery and remove the old battery. (fig. 5)
5. Insert the new battery with the terminals in the direction shown and make sure to replace the foam
cover.
(fig. 6 & 7)
6. Replace the remote control by aligning the white triangle on the side cover to the unlock symbol "
on the handle. (fig. 8)
7. Slide the remote cover so that the white triangle is over the locked symbol "
8. Secure the cover with the screws. Do not over tighten. (fig. 11)
WARNING:
TO REDUCE THE RISK OF ELECTRIC SHOCK-UNPLUG BEFORE
TROUBLESHOOTING
Symptom
Vacuum will not operate
Dust comes out from motor cover.
Reduced efficiency and
motor/speed vibration.
Remote will not operate
TROUBLESHOOTING
Possible Causes
1) No power supply.
2) Faulty power cord.
3) Container full.
4) Switch in the wrong position
1) The cartridge filter is missing or
damaged.
1) There is a blockage in the
nozzle, hose, or the container inlet.
The cartridge filter is clogged by fine
dust.
1) Battery is dead.
27
" . (fig. 9 & 10)
Corrective Action
1) Check power supply – cord,
breakers, fuses.
2) Unplug and check the power
cord. If damaged, have it repaired
by a professional.
3) Empty container.
4) Press the ON 'I' button on the
power head.
1) Attach or replace cartridge filter.
1) Check nozzle, hose and
container inlets for blockage. Take
off the filter and clean it. Or install
new cartridge filter.
1) Replace the battery.
"