Before First Use; Programming Your Coffeemaker; Charcoal Water Filter - Cuisinart Coffee PLUS CHW-12 Manual De Instrucciones

ENjOY THE 2-IN-1 COFFEE PLUS
Your Coffee PLUS
®
let you use the Coffeemaker and Hot Water
System separately, or at the same time.
Perfect for every occasion.

BEFORE FIRST USE

We recommend flushing out both the
Coffeemaker and Hot Water System before
first use.
Coffeemaker: Fill the reservoir with cold
water and follow the directions for Brewing
Coffee. DO NOT ADD COFFEE!
Hot Water System: Fill the reservoir to the
Max fill line and follow directions for Using
the Hot Water System.
Once the system flush is complete, your
Coffee PLUS system is ready to brew and
®
heat water so you can enjoy Cuisinart at
its best!
PROGRAMMING YOUR
COFFEEMAKER
SETTING THE CLOCK
When the Coffeemaker is plugged in,
12:00 will appear.
Turn the Function knob to CLOCK
Hold down the Hour or Minute button until the
clock begins flashing. Press either button to
select the desired time. Hold buttons down to
scroll through the digits, or press and release to
advance one digit at a time. When scrolling, the
numbers will advance slowly and then speed
up. When the number displayed approaches
the desired time, press and release to advance
one digit at a time. Be sure the PM indicator is
on if a PM time is desired.
To finish setting the clock, turn the Function
knob to any other setting or simply wait until
the numbers stop blinking.
SETTING THE AUTO ON TIME
When you turn the Function knob to PROG,
it displays a previously selected Auto On time,
or the default time (12:00pm).
1. Turn the Function knob to PROG
Use the Hour and Minute buttons as above
to program your start-brew time.
2. Turn the Function knob to AUTO ON
LCD will display the current time.
3. Press and release On/Off button
A blue light indicates that the Coffeemaker is
in AUTO ON mode. The blue light around On/
Off will come on when brew cycle begins.
system is designed to
® Both lights will turn off when the Keep Warm
cycle ends.
NOTE: To start brew time at the same time
the next day, simply make sure the Function
knob is on AUTO ON and press and release
On/Off button once more. The blue Auto On
light will turn on.
SETTING THE AUTO OFF TIME
Turn the Function knob to AUTO OFF
Use the Hour and Minute buttons as above to
program your Coffeemaker to shut off from 0 to
4 hours after brew cycle is finished.

CHARCOAL WATER FILTER

Your Coffeemaker comes with two charcoal
water filters that eliminates chlorine, bad tastes
and odors from tap water.
Inserting the Water Filter
• Remove the filters from the polybag and
soak them, fully immersed, in cold tap water
for 15 minutes.
• Lift the water filter holder out of the water
reservoirs from both the Coffeemaker side and
Hot Water System side (see diagram, page 5).
• Press down on the filter compartment and pull
toward you to open.
• Place filter into the holder and snap
it closed. Be careful – improper placement can
tear the filter skin.
• Flush filter by running cold tap water through
holes in bottom of compartment for 10
seconds.
• Allow the filter to drain completely.
• Slide the water filter holder back into the
channel in the water reservoir, pushing it
down to the base of the unit.
NOTE: We recommend changing the water filter
every 60 days or after 60 uses, and more
often if you have hard water.
Replacement filters can be purchased
in stores, by calling Cuisinart
Customer Service, or at www.
cuisinart.com.
Hot Water Charcoal
Water Filter
7
Coffeemaker Charcoal
Water Filter