Set Up Using The Wps Button; Installation As Access Point - MAGINON WLR-755 AC Manual Del Usuario

Set-up
If the computer does not automatically connect to the WiFi Range
Extender, the network must be manually set up by entering the
following (open the network settings of your computer):
IP address: 192.168.10.x (with x in range 2-254)
Subnet mask: 255.255.255.0
Standard gateway: 192.168.10.1

Set up using the WPS button

If your router contains a "Push Button Configuration" or WPS button
(PBC/WPS) it is possible to carry out a quick configuration for new
devices in the network and to also connect the WiFi Range Extender
to the WLAN.
1. Plug WiFi Range Extender into a mains socket.
2. Switch on repeater using the ON/OFF switch. The Power-LED is on.
40
3. Press PBC/WPS key on router. (Further information for activating
the router can also be found in the Operating Instructions of
your router).
4. Hold down the WPS button on the WiFi Range Extender for at
least 6 seconds.
5. The connection is set up after a few seconds.

Installation as Access Point

Installation of WiFi Range Extender as Access Point.
1. Follow points 1 to 5 of section Installation as WiFi Range
Extender, open configuration program of WiFi Range Extender.
2. At the top of the main menu click on "AP".
3. First enter data for Access Point:
• SSID: Enter a name for your WLAN .
Set-up
41