Orbit 28964 Manual Del Usuario página 8

Only connect one valve to
each terminal (station) or
damage will occur
Station 1
Strip wire
Push in and
tighten screw
24VAC SENSOR COM 1
Figure 4
2 3 4 5 6
24VAC
Figure 5
Connect the
transformer here
4. Connect Electrical Transformer Power
Connect power connector to the timer . Insert the
transformer into an 120V electrical outlet . See Figure 5
5. Activate Battery
One Lithium CR2032 battery (included) is required
to retain the program in memory during power loss .
Annual replacement is recommended .
Remove the plastic strip to activate the pre-installed
battery . (See page 12 for battery replacement)
Note: The battery alone will not operate the valves in
your sprinkler system. The sprinkler timer has a built-in
transformer that must be connected to an AC voltage source.
SENSOR COM 1 2 3 4 5 6
Remove plastic
strip to activate
battery
6