Yamaha DVX-S100 Manual De Instrucciones página 20

CONNECTIONS
(RED)
(RED)
Connector
Color tube
(RED)
Color tube
(BLUE)
y
• The connector of the included speaker cable and the terminal of
the subwoofer are classified by color. Connect the same colors.
• The label of the speaker is attached to each speaker cable.
Connect the speakers in accordance with the labels.
• Connect the color tube of the speaker cable to the plus (+) side
of each speaker. If the polarity of the speaker connections is
incorrect, the sound will be unnatural and lack bass.
• A cover is attached to the end of the speaker cable. Connect the
speakers after removing the cover.
• Make sure that the plugs of the system connector cable and the
connectors of the speaker cables are inserted correctly before
inserting them.
Notes
• Do not let the bare speaker wires touch each other or any metal
part of this unit. This could damage this unit and/or the
speakers.
• Do not insert the plug or connector forcibly. Doing so may
damage the plug, connector or terminal.
• Do not scratch, forcibly bend, or pull the system connector or
speaker cable as this may damage the cable, causing loss of
audio output, and may possibly result in a fire or electric shock.
Take particular care in making sure that the cable is not
squashed by a rack or caster.
• Before disconnecting or connecting the system connector
cable, disconnect the power supply cord of the subwoofer and
DVD audio/video receiver.
18
The back of the
Subwoofer
(BLUE)
Connector
(BLUE)
I Using commercially available
speakers and speaker cables
You can use commercially available speaker cables and
speakers except for a subwoofer. If you use them, note the
following.
• Use the speaker whose impedance is 6Ω or higher.
When using the speaker whose impedance is lower than
6Ω, the protection circuit may start working or this unit
may be damaged.
• Use magnetically shielded speakers. If this type of
speakers still creates the interference with the monitor,
place the speakers away from the monitor.
• Use the speaker cable that is as thick as the included
cable. Too thick cables cannot be used.
Exchanging the speaker cables
3
4
1
Remove approximately 15 mm (9/16") of
insulation from each of the speaker cables.
Twist the exposed wires of the cable together to
prevent short circuits.
2
Open the tab.
3
Pull the inserted bare wire of the speaker
cable from the connector and insert the bare
wire of the commercially available speaker
cable.
4
Return the tab to secure the wire.
2
Tab
1
15 mm