22
Problem
Loud "cooking and pumping"
noises are heard during the
drawing process.
N, M and O are all flashing at
the same time, it is not possible
to draw any water.
If you are unable to rectify the problem, please contact Customer Service.
Technical data
Power connection (voltage/frequency)
Heater wattage
Maximum static pump pressure
Maximum water tank capacity (without filter)
Length of power cable
Dimensions (H x W x D)
Weight, empty
Robert Bosch Hausgeräte GmbH
Possible cause
The filter is set to "yes" (see
chapter " BRITA MAXTRA
water filter system") but there
is no filter in place. Build-up of
limescale in the appliance.
The used water is particularly
calciferous. Build-up of
limescale in the appliance.
The appliance has a fault.
Remedy
Descale the appliance as
described in the chapter
"Descaling".
Finally, programme the correct
setting.
The appliance must be descaled
more often than the N symbol lights
up. Follow the instructions outlined
in the chapter "Descaling".
Disconnect the appliance from
the power supply and contact
Customer Service.
220-240 V / 50 Hz
1600 W
3.3 bar
2 litres
80 cm
290 x 223 x 267 mm
2.3 kg
en