Husqvarna CS 2512 Manual De Instrucciones página 12

9. Cooling water connections
There are two connections on the machine for water
spears and one for the incoming water. Besides
cooling the wire with these, the wire is also rinsed
when it returns to the machine and when it leaves the
machine by small nozzles.
10.Rubber wheels
To facilitate transport. The wheels can be dismantled in
some situations to facilitate access on certain jobs.
This is done by removing the split pins that lock the
wheels on the wheel axle.
11.Wire boom
Holds the wire in against the magazine when the
magazine is run in. This prevents the wire tangling
when not tensioned, e.g. when changing the wire or
when changing the number of wheels used in the
magazine.
12.Anchor beam
Adjustable beam with a longitudinal slot. By moving
this beam sideways, you can position the anchor bolt in
a suitable position without the need of moving the
entire saw when anchoring the saw before cutting.
An additional anchor beam is placed under the saw.
The anchor bolt is secured in this beam when
horizontal cutting.
13.Pressure reduction block
The pressure reduction block is fitted between the
hydraulic unit and the hydraulic hoses for the input
supply. There is a valve located on the pressure reduc-
tion block, this is used to control the magazine tension.
14.Swivel wheels
The swivel wheels supported on bearings are located
where the wire enters the saw and out through the
saw. The swivel wheels help to guide the wire so it is
positioned correctly in the saw and can either be
locked in a fixed position or used in the unlock position
so that the wheels follow the wire.
15.Guide wheel
Guides the wire from the magazine to the drive wheel.
When the drive wheel unit is adjusted, the guide wheel
is set automatically depending on the number of
12 - English
magazine wheels used.
Accessories
1. Water spear
Connected to the water connections on the saw and
used to guide cooling water into the cut to cool the wire
and to bind the concrete dust.
2. Idler wheels
Husqvarna idler wheels are designed to smoothly
guide the wire as efficiently as possible. By using idler
wheels the number of sharp corners to cut around can
be reduced, which means that more of the cutting
capacity is used for material removal.
3. Cleaning brush
Can be connected to the water hose and then used to
clean the machine after use.
Operator's Manual CS 2512