Sears Craftsman 286.25574 Manual De Uso página 15

CUTTING INSTRUCTIONS cont,
WHAT IT CUTS
The blades supplied with the saw are universal in application and will give clean,
smooth cuts in:
- Wood up to a maximum depth of 11/2inch.
. Mild steel tubing or sheets with a maximum wal! or sheet thickness of 1t8 inch.
. Copper, stainless steel, aluminum, cast iron tubing or sheets with a wall thickness of
1/8 inch. When cutting these materials, the wax lubricating sticks MUST BE USED.
- Plastic pipe or sheets of a wall thickness of 1/8 inch,
IMPORTANT: The Twin Cutter WILL NOT CUT masonry, cement or brick material.
IMPORTANT: Once the blades become worn, chipped or dull, they MUST BE replace
immediately
CUTTING ALL MATERIALS
1, ALWAYS have the saw blades at full speed before contact!ng workpiece.
2oALWAYS hold the saw so the blades feed perpendicularly Into the workpiece, Hold
the saw at an approximate 30 ° angle.
3. ALWAYS keep your body positioned to either side of the saw blades, but not fn tine
with the saw blades°
4. Feed the blades into the workplece until the desired cut is made,
5oThe kerf (width of the cut) of the twin blades ts approximately 1,/8th of an inch.
Always be sure to allow for this kerfwidtho
This Twin Cutter Saw with it's special blades and cutting action is a highly
versatile tool that quickly and efficiently provides smooth, efficient cuts a wide
variety of materials:
Flat Iron Bar
Thin Plato Shaped Plate
15
I
I
i
I
5-25-06