Sears Craftsman 286.25574 Manual De Uso página 21

PROBLEM
An unusually
large amount
of sparks
A lot of wear
in sections
Blades are
breaking
Posslbta causes
of broken teeth
CAUSE
1,Damagedteeth
2. Feedspeedistoosiow
3. Bluntlee[h
1. Feedspeed is toofast
2, Damaged teeth
3. Blunt teeth
4. Notcuttingperpendicular
to worksurface
1_Damaged teeth
2. Feed speed is too fast
3., Blunt teeth
4. B_ades have buckled
5. Blades have burned out
t. Feed speed is too fast
2. The surface being
cut is too hard
3, The teeth have been
damaged by impact
4. Blades were not
installed properly
5, Blades are burned out
6. Not cutting perpendicular
to wod_surface
SOLUTION
1.,Replace btades
2o Increase feed speed
3. Replace blades
1 Reduce feed speed
2. Replace blades
3oReplace blades
4oHold saw perpendicular
to work surface
1oReplace blades
2. Reduce feed speed
3. Replace blades
4o Replace blades
5. Replace blades
1. Reduce feed speed
2, Replace b_ades
3, Replace blades
4. Replace blades and follow
the proper blade tnstalEation
instructions
5, Replace blades
6, Replace blades and always
hold saw perpendicular to
work surface when cutting
Z_WARNING:
This Twin Cutter saw uses specially designed 61fs-in, blades
and no other types of blades should ever be used, Other blades will not operate
safely in this saw and could result in serious personal injury
The following accessories for your Twin Cutter saw are available at your local
Sears store,.
9-61t31 M A packaged set of 2 UniversalTwin Cutter Saw Blades
9 26678 _ 6 PackagedWa× Lubricating Sticks
I Z_ WARNING:
The use of attachments or accessories that are not
! recommend edmight bedangerous
21
!
I
1
|
t