Using The Co-Sleeping - tuctuc COLECHO-PARQUE CO-SLEEPING CRIB/PLAYPEN Manual De Instrucciones

INSTRUCTIONS FOR USE & ASSEMBLY
CO-SLEEPER USE (ALONGSIDE A BED)
IMPORTANT INFORMATION:
Follow instructions carefully to avoid any risk of falls or asphyxiation.
1. Unlock the safety system that holds the two zips in place. Using the side zips, open the mesh window side of
the crib. Then, undo the zip at the front of the upper bar. Unzip fully.
2. Detach the tube attachment and pull the tubes partway out. Once done on both sides, lower the crib bar and
attach to the base of the crib using the lower buttons.
WARNING! Only use the crib with one side lowered in "co-sleeper" position.
1
2
2
3
4
1
3. Place the crib against the adult bed and check crib height against bed mattress height. The mattress must
be aligned with the height of the edge, or the lowest setting. In "co-sleeper" mode, the 2 crib legs must be at
the same height.
4. Use the two straps provided to attach the crib to the parental bed. Clip the buckles to the inner part of
the two panel supports (fig. 17); then, arrange the straps around the structure / slats of the parental bed
from below to above and tighten the buckles to hold everything in place.
71