Air Connection; Cleaning The Motor - Ega Master Aqua Master Manual De Instrucciones

Line, fitting and hose must have the required cross-section to obtain sufficient air (600 litres per minute).
Regularly check and clean the air inlet screen.
Operating pressure must not exceed 6 bar.
Rins the motor with cleansing oil after approx. 10 working hours. (Cleansing and oil-ampoule Part Number Nr. 9
9902 0100). Fill the oil into the air connection. Connect air and start the motor (approx. 20 seconds at free speed).
Vanes are main wear parts. Replace them in due time. They are considered to be worn when the height "H" is less
than 7 mm.
Disassembly and assembly should only be performed with the assistance of the sectional drawing.
All parts can be dismantled by light pushing or knocking (wooden base / rubber hammer).
Clamp the machine at the gearbox housing into the vice. Use plastic jaws that enclose the gearbox housing as far
as possible and unscrew the handle. Pull out the motor. Open the motor on the toothed side for changing the vanes,
the front end plate, the cylinder bushing or the grooved ball bearings. This will be done by holding the motor on the
cylinder bushing and knocking the toothed side of the rotor against a wooden base. During installation of new vanes
take care that the vanes do not jut out of the rotor.
Attention! The planetary gear can be completely removed from the gearbox housing. Lever up
the three-jaw chuck with the help of two levers (or special tool) from the planet carrier output shaft. Lightly knock the
edge of the gearbox housing (on the thread) on a wooden base.
The gearbox comes off and can be drawn out of the housing easily. Grease the gearbox at reassembly.
12

AIR CONNECTION:

CLEANING THE MOTOR:

WEAR OF VANES:
DISASSEMBLY
MOTOR
GEARBOX 79904 / 79905