Replacement Parts - Schumacher PBI1812 Manual De Usuario

PROBLEM
The booster won't power my
12V device.
The battery in the booster
won't hold a charge.
11. SPECIFICATIONS
Internal Battery Type
Internal Battery Output Voltage
Internal Battery Cranking Amps
Internal Battery Rated Capacity
DC Power Outlet (Max. Continuous Load)
Application Range
Booster Cables
Dimensions (H x W x D)
Booster Weight
Charger Input
Charger Output (Booster Input)
Charging Time (Approximate)
Charger Weight
12.

REPLACEMENT PARTS

Wall Charger (EU) ...........................................................................................93026888C
Wall Charger (UK) .......................................................................................... 93026889G
Wall Charger (Australia) ................................................................................... 93026890I
POSSIBLE CAUSE
The 12V device is not
turned on.
The booster battery is not
charged.
The 12V device draws more
than 15A or has a short circuit
The battery is bad (will not
accept a charge).
Maintenance-free AGM Lead-acid
12V DC/6 cells
323 Amps
22 Ah
12V DC/15 A
12V DC/6 cells (20 Ah – 120 Ah)
4 AWG (21.14 mm
28 x 30.5 x 9 cm
7.2 kg
100–240V~, 50/60Hz
17V
30 Hours
0.12 kg
36
• •
REASON/SOLUTION
Turn on the 12V device.
Check the battery charge
status by pressing the button
on the front of the booster.
See LED Indicators section of
this manual.
Disconnect the 12V device.
The internal breaker will
automatically reset after a
minute or two. Try the 12V
device again. If it happens
again, replace the 12V device.
Have the battery checked.
), 28 Inches (71.12 cm)
2
700mA