Installation; Installing Hide-Away Unit - Pioneer CD-VS33 Operación Manual

Installation

Note:
• Before finally installing the unit, connect the wiring temporarily, making sure it is all connected up
properly, and the unit and the system work properly.
• Use only the parts included with the unit to ensure proper installation. The use of unauthorized
parts can cause malfunctions.
• Install the unit where it does not get in the driver's way and cannot injure the passenger if there is a
sudden stop, like an emergency stop.
• When mounting this product, make sure none of the leads are trapped between this product and the
surrounding metalwork or fittings.
• Do not mount this product near the heater outlet, where it would be affected by heat, or near the
doors, where rainwater might splash onto it.
• If this product is installed in the passenger compartment, anchor it securely so it does not break free
while the car is moving, and cause injury or an accident.
• If this product is installed under a front seat, make sure it does not obstruct seat movement. Route
all leads and cords carefully around the sliding mechanism so they do not get caught or pinched in
the mechanism and cause a short circuit.
• Install the controller in a safe place where it can be easily operated from the rear seat.
• Never install the controller on the dashboard where it will be exposed to the direct rays of the sun.
It could be damaged by high temperatures.
• In attaching L-fixtures to the controller unit with screws, be careful not to overtighten the screws or
tighten them slanted. An expanded screw hole might result, disabling attachment of the L-fixtures.
• The L-fixture can be bent to match the installation location.

Installing Hide-away Unit

Car mat
Hide-away unit
Velcro tape
(hard)
10