Product Safety Information; Product Specifications - Ingersoll Rand QA90 X 90 Especificaciones Del Producto

Product Safety Information

Intended Use:
These Air Drills are designed for drilling, honing, reaming and hole sawing.
For additional information refer to Product Safety Information Manual Form 04580353.
Manuals can be downloaded from ingersollrandproducts.com

Product Specifications

Models
QA05
QA08
QA12
QA17
QA21
QA27
QA35
† K = 3dB measurement uncertainty
pA
‡ K = 3dB measurement uncertainty
wA
Sound and vibration values were measured in compliance with internationally recognized
test standards. The exposure to the user in a specific tool application may vary from these
results. Therefore, on site measurements should be used to determine the hazard level in
that specific application.
Installation and Lubrication
Size air supply line to ensure tool's maximum operating pressure (PMAX) at tool inlet. Drain
condensate from valve(s) at low point(s) of piping, air filter and compressor tank daily. Install a
properly sized Safety Air Fuse upstream of hose and use an anti-whip device across any hose
coupling without internal shut-off, to prevent hose whipping if a hose fails or coupling
disconnects. See drawing 16577397 and table on page 2. Maintenance frequency is shown in a
circular arrow and defined as h=hours, d=days, and m=months of actual use. Items identified as:
1. Air filter
2. Regulator
3. Lubricator
4. Emergency shut-off valve
5. Hose diameter
6. Thread size
16572281_ed3
Free Sound Level dB(A)
Speed
rpm † Pressure (L
500 77.0
850 77.2
1270 77.1
1750 77.0
2100 77.0
2700 76.8
3500 77.1
WARNING
(ISO15744)
) ‡ Power (L
p w
88.0
88.2
88.1
88.0
88.0
87.8
88.1
* K = Vibration measurement uncertainty
7. Coupling
8. Safety Air Fuse
9. Oil
10. Grease - during assembly
11. Grease - through fitting
Vibration (m/s²)
(ISO28927)
) Level *K
< 2.5 --
< 2.5 --
< 2.5 --
< 2.5 --
< 2.5 --
< 2.5 --
< 2.5 --
EN
EN-1