Cleaning Procedure - Mr Coffee BVMC-EM6701 Serie Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

TO DELIME WATER RESERVOIR:
1.
Fill the reservoir with fresh, undiluted white household vinegar.
2.
Allow appliance to sit overnight with the vinegar solution in the water reservoir.
3.
Discard vinegar by removing the reservoir and turning it upside down over the sink.
4.
Rinse the water reservoir thoroughly with tap water by filling the tank half full with
water and then pouring the water back out into the sink, repeating this step twice.
TO DELIME INTERNAL PARTS:
1.
Make sure you delime the inside of the water reservoir first by following the
"Deliming" steps above.
2.
Make sure to switch the on/off button to the off "O" position and the power cord
is disconnected from the electrical outlet. Fill the reservoir with undiluted white
household vinegar.
3.
Insert the porta-filter (with filter and no coffee) and place a large empty cup on top of
the drip tray and under the porta-filter.
4.
Plug the power cord into the electrical outlet.
5.
Press the on/off button to switch the unit on "I", once the 2 control panel lights
(Espresso heater " " and Steam heater " ") turn solid press the Automatic
Espresso "
stop automatically.
6.
Place a large empty cup (with at least 325 mL/ 11 fl. oz. capacity) under the frothed
milk dispensing tube. Fill the milk reservoir with water and place it back on the unit.
Turn the Froth Control Knob counter clockwise to the clean position "
the Clean "
you no longer see any milk coming out of the tube, or let the cycle run until it stops
automatically.
7.
Repeat Steps 1 – 6 as necessary using only tap water to rinse any remaining
traces of vinegar out of the machine.
CLEANING NOTIFICATION
After 200 cycles the Cleaning Notification will activate.
1.
The Cleaning Indicator Light will remain on as a notification until the cleaning
procedure is completed.
a.
If you brew another espresso. latte. or cappuccino. the cleaning light will turn
off momentarily, but will start flashing after completion of the brew.
b.
When the unit is powered off the Cleaning Indicator Light will turn off.
c.
When the unit powers down and goes into sleep mode, the cleaning indicator
light will turn off.

CLEANING PROCEDURE

1.
Pour a solution of 50% white vinegar and 50% clean water into the water tank. Stir
the solution with a spoon to make sure it is properly mixed.
2.
Rotate the milk tank knob to the clean position. Place a large cup under the frothed
milk dispensing tube.
3.
Press the clean button for 5 seconds to activate the clean mode.
a.
The light slowly pulses, same as the brew cycle pulse through the entire
cleaning cycle.
b.
The pump will turn on and off multiple times for about 12 minutes. The cleaning
light will then turn off indicating that the cleaning cycle is completed.
4.
Pour out any remaining solution from the water tank and replace with clean water.
Fill with clean water up to the Max level line.
BVMC-EM6701 Series_17ESM1.indd 15
" Button twice. The vinegar will start flowing through the unit and it will
" button to activate the clean function. Let the cleaning cycle run until
E n g l ish -15
" then press
12/7/17 9:59 AM

Publicidad

Tabla de contenido
loading

Tabla de contenido