Operation Instructions; Cleaning Bedding; About The Sensors - IRIS IC-FDC1U Manual De Usuario

USAGE INSTRUCTIONS (OPERATION INSTRUCTIONS)
1. Adjust the collection head angle.
Please place the vacuum on the floor, then adjust the angle
up and down by hand.
• Please adjust the vacuum body to the horizontal
position, which should be used for soft surfaces such
as bedding.
• The collection head is fastened in horizontal position
by a magnet to keep it in place during use.
2. Unlock.
Hold the menu button for 3 seconds, wait for the safety lock
indicator to light up, then start cleaning as directed below.
• Safety lock will automatically lock again after one
minute of non-use.
• Device will not work when locked. Pressing the menu
button to start when it is locked will cause the safety
light to blink.
3. Insert the battery into power socket.
Pressing the menu button changes the mode.
• Press the menu button to change to high mode.
• Press the menu button again to change to low mode.
4. Finish.
Press the menu button to change the mode until the vacuum
stops and the indicator light shuts off.
• Device will automatically lock after one minute of
non-use.
• Please follow step 2 to restart.
• Battery level indicator light will blink
when battery power is low.
• When battery runs out of power,
battery level indicator light will blink
rapidly before shutting off, and motor
will stop. Please recharge.
Notice:
• Do not use this vacuum cleaner to clean the following objects:
· Liquid · Wet litter/debris · Powder
• Please do not clean large amounts of litter/debris in one pass to avoid blocking the intake port and decreasing suction.
• Do not use on floors, walls or furniture. Do not pull on the main body and avoid hitting walls or furniture.
• Empty the dust cup after use to avoid decreased suction or issues with the sensor.
Storage status
Carpet or car cushion
material angle.
Bedding
appliance
angel
Safety lock
High
Low
Battery Level
Safety Lock
(hold for 3 seconds)
Menu
ON/OFF
Indicator light
High
Low
High
Battery Level
Safety Lock
(hold for 3 seconds)
Low
Stop
Menu
ON/OFF
Indicator Light
High
Low
Battery Level
Safety Lock
(hold for 3 seconds)
Blinking: Low power
Blinking rapidly (then off): No power
Menu
ON/OFF
· Broken Glass · Sharp or pin type objects
5
USAGE INSTRUCTIONS (CLEANING BEDDING)
1. Please spread out the bedding or mattress pad to lay flat (no folds).
2. Adjust the vacuum to the horizontal position.
3. When the device is in high mode, move back and forth every 10 seconds.
Please do not forcefully press down the collection head.
Adjusted to 90°, the device will not work.
• Adjusted to the horizontal position, the collection head is fastened in
place by a magnet.
• When cleaning furniture, cushions, carpets, etc. with the collection
head in between, the head is not locked in place and may be unstable.

ABOUT THE SENSORS

Dust Sensor:
Dust and dust mite sensor works during use, and
light indicates the amount of dust on the surface
area.
*When cleaning carpets or other items with high
dust levels, indicator light will not turn green.
Bedding Sensor:
Device will conserve power and decrease speed
when both sensors lose contact with the object
being cleaned.
Top
Dust indicator light
Red: Not clean
Yellow: Almost clean
Green: Clean
Bottom
Bedding sensors
6
Magnet