Set Up Instructions - 3M 240c Serie Manual Del Usuario

Set Up Instructions

3M™ HVLP equipment is for professional use only.
Hazards can occur from equipment misuse. Any
misuse of the equipment or the accessories, such as
over pressurizing, modifying parts, using incompatible
chemicals and fluids, or using worn or damaged parts
can cause serious bodily injury, fire, explosion or
property damage. Please read and follow all safety
statements, user instructions and owner's manuals.
Never point a spray gun at anyone or any part of the body.
Never place your hand or fingers in front of a spray nozzle.
Never try to stop or deflect leaks with your hand or body.
Spray Gun
1/2 Pint
Cup
Assembly
Fig. 2
Turbine/Compressor
Atomizing
Air Hose
E (Far Side)
D
Never alter or modify any part of this equipment. A
malfunction could result.
Check your spray equipment regularly. Repair or replace
worn or damaged parts immediately.
Always use 3M™ HVLP replacement parts. Only these
parts are designed to work with your equipment.
Attached Cup Applications
For touch-up or small projects, the turbine/compressor
unit can also be used with an attached ½ pint or 1 quart
cup. See cup manual for set up instructions.
A. Female end quick
disconnect of atomizing
air hose (whip hose)
B. Male end quick
disconnect of atomizing
air hose (whip hose)
C. Quick disconnect/Bleeder
control valve
D. Female fitting air hose
E. Turbine Discharge
F. Female end of fluid hose
7
Fig. 1
G. Male end fluid hose
H. Pressure relief valve
I. Male fitting (air inlet) of
regulator assembly
J. Quick disconnect of the
compressor hose
K. Male fitting of compressor
hose
L. Quick disconnect at the
compressor