Publicidad
Idiomas disponibles
Idiomas disponibles
1
Provide suitable reinforcement
behind finished wall for lavatory
mounting screws.
* Determine horizontal center line
location of support from fixture.
NOTE: If replacing an existing sink
be certain to shut off water supply
before removing old sink.
2
Top of Pedestal
Lavatory slab
For example only
Place lavatory and pedestal into installed position.
Level and square the lavatory and pedestal assembly.
3
Mark lavatory and pedestal screw locations through
the mounting holes.
4
Remove lavatory and
pedestal from installed
position. Drill pilot holes for
lavatory and pedestal
anchor screws or lag bolts.
Note: Some models are supplied with lag bolts, anchor screws, or
steel hangers for lavatory installations only. Other models and all
pedestals are not provided with mounting hardware. Various
pedestal screw sizes and types are available to the installer at
local hardware outlets.
5
ANCHOR SCREW INSTALLATION
Install lavatory anchor screws leaving 1-7/8"
threaded end exposed as illustrated.
Lavatory
Anchor
Screw
Nut
Washer
IMPORTANT: Final assembly of nut and washer or lag bolt method shown for reference only.
C/L of 2X6
Support
*
Finished
Floor
1-7/8"
6
Following manufacturer's
instructions, install faucet and
drain assembly (not included).
Be certain to apply a bead of
sealing putty on the underside
of the drain (area "A") in order
to ensure a watertight seal
between the lavatory and drain.
Remove excess putty after
installing drain on lavatory.
7
Return the fitted lavatory to the
installed position. Connect trap to
drain assembly hand tight to check
alignment. It may be necessary to
cut off part of the tailpiece (area
"B") or part of the horizontal leg of
the trap (area "C").
8
Secure lavatory to wall as
shown in Step 5. Install
washers and hand tighten nuts
or lag bolts. Level and square
the unit. Connect hot and cold
supply lines to the shut-off
valves. Tighten trap joints for
watertight assembly.
9
Rear
View
ALTERNATE METHOD: COMPONENTS NOT INCLUDED
LAG BOLT INSTALLATION
Use lag bolts to secure lavatory as illustrated.
Lavatory
Steel
Hanger
Lag
Bolt
Washer
Lavatory
2
C
B
Shut-Off
Valves
Note: Space constraints
may dictate method of
fastening pedestal to floor.
7 3 0 2 3 0 7- 10 0
Publicidad
