Audio Settings; Aux Mode - HQ-Power HQWS10001 Manual Del Usuario

Manually Tune FM
Use the tuning/enter dial to manually tune the radio in FM mode. Save as a preset if
required. This helps in getting a clearer signal in areas where signal is poor.
FM Menu Options
Press and hold the info/menu button until [Scan Setting] is displayed.
Use the tuning/enter dial to cycle through the options. Then, press the same dial to
select an option:
Scan Settings
You can change the auto tune search ability between [All Stations] and [Strong
Stations]. Select [Scan Settings] from the menu options.
Use the tuning/enter dial to cycle between either [Strong Stations] or [All Stations].
Press the same dial to select the required option. The asterisk in the top right corner
indicates the current selection.
You will be sent to the previous menu once a selection has been made. Press the
info/menu button to return to the main screen.

Audio Settings

Use the tuning/enter dial to cycle between [Stereo Allowed] and [Forced Mono] options.
Press the same dial to confirm. The asterisk in the top right corner indicates the current
selection.
5.5

Aux Mode

Selecting the AUX Mode
To select the AUX mode, press mode until [AUX] is displayed.
Using the AUX Mode
Connect a 3.5 mm jack cable from the device (mobile, MP3 player, tablet...) to the AUX
port at the back of the appliance. Make sure the connected device has the volume
output at maximum in order to play the sound through the radio. Use the volume
control to regulate the end volume output.
V. 01 – 27/03/2020
HQWS10001
Scan Setting → Audio Set → System
7 ©Velleman nv