Backlight - HQ-Power HQWS10001 Manual Del Usuario

HQWS10001
Time/Date
This option allows you to manually set the time and date.
Once selected from the [Time] submenu, you will see the hours flashing. Turn the
tuning/enter dial to cycle through the hours and press the same dial to select the
required hour value.
Once the hours have been set, the minutes are flashing. Repeat the process above and
set the minutes. Once selected, you will move on to the next screen for setting the
date.
Cycle through the numbers with the tuning/enter dial and press the same dial to select
the value. Move to the next value to set. When the last value is set, the display will
confirm the new time and date has been saved.

Backlight

You can change the brightness and light duration of the display.
Turn the tuning/enter dial to cycle through the options and press the same dial to select
an option:
Time Out → On Level → Dim
Time Out
This option allows you to set the duration of the time before the display dims. Choose
from the options by turning the tuning/enter dial and press the same dial to select:
On → 10 → 20 → 30 → 45 → 60 → 90 → 120 → 180 seconds
The asterisk in the top right corner indicates the current selection.
On Level
This option lets you set the active display light level. Choose from the options by turning
the tuning/enter dial and press the same dial to select:
High → Med → Low
The asterisk in the top right corner indicates the current selection.
V. 01 – 27/03/2020 9 ©Velleman nv