Charging A Smartphone Or Cell Phone - Hitachi Koki UR 18DSAL Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

12. Select radio bandwidth.
Press the Select button to display "AM" or "FM".
FM
13. Press the Enter / Information button.
14. Press the Select button to display a preset station.
P2 FM 79.5 MHz
To select a station by broadcast frequency, use
the Search button.
FM 80.0 MHz
15. Press the Enter / Information button to complete
setup.
will be displayed on the LCD.
○ To cancel the radio alarm setting, go to "RADIO
ALM" once again and change the setting to
"OFF".
NOTE
The radio's volume will be at the level when the
radio was last switched OFF.
CHARGING A SMARTPHONE OR CELL
PHONE
Devices such as a smartphone and mobile phone
can be recharged by connecting the device to this
radio.
The recharge function is only available for the "FM",
"AUX" or "Bluetooth" mode. (Recharging cannot be
done in "AM" mode.)
NOTE
○ When recharging in "AUX" or "Bluetooth" mode,
set the volume output at 20 or less.
The radio is designed to deactivate USB output
and disable the recharging of smartphones and
mobile phones when the volume is at 21 or more.
(For "FM" mode, USB recharging will continue
even if the volume output is 21 or more.)
○ On rare occasions, sound output may be
interrupted or power could shutdown during USB
recharging.
If either should occur, lower the volume level or
stop recharging with the USB.
○ The radio is designed to deactivate USB output
and disable the recharging of smartphones and
mobile phones when the power level of the battery
is low.
Should the aforementioned occur, recharge the
battery or replace with a fully charged battery.
○ If the voltage is low when the AC adapter is in use,
the USB output may be cut off , discontinuing any
recharging.
1. Using a commercially available USB connection/
recharge cable, connect to the USB charging port
located in the radio's storage case for external
devices. (Fig. 9)
USB charging
port
USB
charging cable
2. Secure the smartphone with the holders and
close the cover. (Fig. 8)
(See "Secure the external device" on page 16)
NOTE
○ Use a fully charged battery when using a battery
as this device's power source.
You will not be able to recharge smartphones
or mobile phones when the battery power level
becomes low.
○ The time required for charging varies in
accordance with the smartphone or mobile phone
being recharged.
○ Do not use the recharge function for any devices
other than a smartphone or mobile phone.
○ The radio may not be able to recharge some
smartphone or mobile phone models.
Two recharge cable holders, one for Android and the
other for Apple (Lightning connector) are included.
Select the holder that best suits your device.
English
Smartphone
Recharge
cable holder
Fig. 9
19

Publicidad

Tabla de contenido
loading

Tabla de contenido