Environmental Orientations And Recommendations; Terms Of Warranty - Schulz MOTOESMERIL 6 Manual De Instrucciones

12. ENVIRONMENTAL ORIENTATIONS AND RECOMMENDATIONS

Disposal of solid waste (parts in general and product packaging)
The generation of solid waste is an aspect that the user must take into consideration, in the use and maintenance
of his equipment. The environmental impacts can cause signifi cant changes in soil quality, in the quality of super-
fi cial and underground water and in the population's health, through the improper disposal of discarded waste (on
the streets, receiving bodies of water, landfi lls or vacant lands, etc.).
Schulz Compressores S.A. recommends the management of the waste created by the product since its genera-
tion, handling, transport, treatment until its fi nal disposal. A proper management must consider the following
steps: quantifi cation, qualifi cation, classifi cation, source reduction, selective collection, recycling, storage, trans-
port, treatment and fi nal destination.
The disposal of solid waste must be done according to the regulative requirements of the legislation in vigor.

12. TERMS OF WARRANTY

Schulz Compressores S.A., within the limits of this Term, assures the fi rst buyer/ user of this product
the warranty against manufacturing defects of the equipment for a period of 6 (six) months (including
the Legal Warranty of 90 (ninety) days) , counting from the invoice date.
WARRANTY GENERAL CONDITIONS
A. Warranty reception will only be held in view of presentation of the original invoice, preferably on behalf of
the customer, containing CNPJ / CPF.
B. Any warranty service must be performed solely and exclusively by SCHULZ AUTHORIZED DEALER.
C. It is not included in the warranty: parts that naturally wear out with regular use and that are infl uenced by
installation and way of use of the product, such as: bearings, electric cord, cover, power trigger, accessories,
motor and sanding. Schulz will be responsible for expenses of services that involve the components listed
above only when a SCHULZ AUTHORIZED DEALER observes defects in material and workmanship defects.
D. SHULZ S.A. is responsible for replacing parts that experience problems during the warranty period and are
characterized by a manufacturing problem, so that in this term the replaced part will have a warranty against
defects in material and workmanship for 30 days. Parts that experience default out of the warranty period
will be on the customer's responsibility.
E. Warranty will not charge installation and cleaning services, bearing replacement, bearing relubrication, ad-
justments requested by the customer, damages to the external part of the product as well as the ones that
it may come to suffer due to improper use, tank oxidation due to improper draining, installation not in ac-
cordance with the Instruction Manual, corrosive agents or other contaminants, neglect, external agents, bad
weather, modifi cations, use of improper accessories, poor dimensioning for the intended application, falls,
perforations, operation different form the directions of the Instruction Manual, power connections to impro-
per voltages, incorrect voltage conversion of the electric motor contrary to the purchase of the compressor or
to power lines subject to excessive variations or overloads.
F. No representative or dealer is authorized to receive the product from the customer and send it to SCHULZ
AUTHORIZED DEALER, or give any information on behalf of Schulz Compressores S.A. about the progress of
the service. Schulz Compressores S.A. or SCHULZ AUTHORIZED DEALER will not answer for possible dama-
ges or delay as a result of the noncompliance with the aforementioned.
G. Any repairs or compensation for damages caused during transportation (round trip to SCHULZ AUTHORIZED
DEALER) performed by the customer are not covered by the warranty.
H. The warranty of the starters and of the electric sensors will only be given if they have not gone under any
kind of violation. The warranty will not include modifi cations in the parameters of the starter that have been
performed by non-authorized people and that do not have technical knowledge of the product, and Schulz
37