Switching Off; Cleaning And Maintenance - Perel FT120C Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 32
7.
Operation
7.1
Start-Up
1. Fill the tank with the appropriate fuel. The fuel gauge on top of the tank allows you to
check the level.
2. Next, connect to an earthed mains socket.
3. The power indicator will light and the display will show the ambient temperature.
4. Flick the power switch to the on position. If the thermostat control knob temperature is set
higher than the ambient temperature, the device will start. The device will stop if the
ambient temperature is reached.
7.2
Cold Start-Up
At low ambient temperatures, keep a finger on the air vent hole during the ignition. In case of
malfunction (flame failure, reduced airflow, bad combustion), the device will stop and the
indicator light starts flashing (lockout mode).
7.3
Manual Reset/Re-Start
If the device is in lockout mode, check and resolve the lockout problem before re-starting. To
reset, flick the on-off switch to the off position and then again to the on position.
In case of repeated malfunction, please contact your dealer.
7.4

Switching Off

Flick the on-off switch to the off position and disconnect from the mains.
8.

Cleaning and Maintenance

General
Before cleaning, switch of the appliance, disconnect from the mains and allow to cool
completely.
Never immerse the appliance in water or any other liquid. Protect it from splashes and spraying
liquid.
Occasionally wipe with a damp cloth to keep it looking new. Do not use harsh chemicals,
cleaning solvents or strong detergents.
Keep the air inlet and fan free from dust and dirt. To clean inner parts, gently blow compressed
air through the air inlet.
Before storing, make sure the device is perfectly cool and dry. Cover the device with a plastic
bag and store in a dry, well-ventilated place.
Qualified personnel must carry out the following checks before every seasonal use:
Nozzle
Carefully unscrew the nozzle fitting. Blow compressed air through the nozzle orifice to free it
from dirt. Replace the nozzle if necessary.
V. 05 – 23/04/2020
FT120C/FT130C
6
©Velleman nv

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Ft130c

Tabla de contenido