ENGLISH
Unplug from the mains when not in use.
Press the "+" or "-"button to decrease or increase the temperature until the desired
temperature is reached.
Take approximately one inch section of hair
Hold the handle and wrap hair around heated barrel
Hold for approximately 10 seconds for the curl to form before releasing the hair.
For tighter curls use smaller sections of hair, for looser curls and waves use larger sections.
Repeat as necessary
Due to the extreme heat capabilities of this styler, extra care should be taken when using.
While heating, during use and cooling, place on flat, smooth, heat-resistant surface. Only
hold unit at the end of the handle.
This is a high performance product, avoid frequent use to prevent damage to hair.
Please note regular use of styling products may deteriorate the coating.
Do not scratch the surface, as this will deteriorate the effectiveness of the coating.
Ensure the unit is unplugged and cool. Wipe clean any build up of styling products with a damp
cloth. Do not use an abrasive cleaning fluid to clean, as damage will occur.
WARNING – FOR ADDITIONAL PROTECTION THE INSTALLATION
OF A RESIDUAL CURRENT DEVICE (RCD) WITH A RATED RESIDUAL
OPERATING CURRENT NOT EXCEEDING 30mA IS ADVISABLE. ASK AN
ELECTRICIAN FOR ADVICE.
WARNING – THIS APPLIANCE MUST NOT BE TAKEN INTO A BATHROOM,
IT SHOULD NOT BE USED NEAR BATHTUBS, SHOWERS, BASINS OR
OTHER VESSELS CONTAINING WATER OR OTHER LIQUIDS.
THE STYLER SHOULD BE UNPLUGGED FROM MAINS SUPPLY WHEN NOT
IN USE.
2
100222 REM IFU Ci95_21L.indd GB_2
100222 REM IFU Ci95_21L.indd GB_2
IMPORTANT INSTRUCTIONS
CLEANING AND MAINTENANCE
SAFETY CAUTIONS
This product is not suitable for use in bath or shower.
31.03.10 12:53
31.03.10 12:53