System Requirements - Speedlink 4in1 Force Feedback Racing Wheels Manual De Uso

4. Press the handbrake button (differs from game to game).
5. Press the mode button again to exit teach mode.
GB
Setting the gear shift to manual operation
1. The functions of the gear shift buttons can be changed to suit the
game. Check which button is assigned the gear change function in the game
you are playing.
2. Press the mode button repeatedly until you are in teach mode.
3. Move the gear shift up, down, right or left.
4. Press the button with the gear change function.
5. Press the mode button again to exit teach mode.
Note: If the foot pedals don't work in the game, you can move the gas and bra-
king functions to the foot pedals using the button re-assignment function in teach
mode!
Connecting to a PC
Note: Do not connect the racing wheel to a USB hub: it will only work when con-
nected directly to the USB port of your PC.

System requirements

• IBM PC
• Windows 98SE/2000/Me/XP
• USB port
Software installation
1. Insert the supplied software in the appropriate drive.
2. Click on Start/Run, then Browse and select the appropriate drive.
3. Select setup.exe.
4. Click on OK.
5. Follow the instructions on the screen.
6. When software installation is finished, plug the USB adapter into the
PS2 socket of the racing wheel. Then connect the USB cable to the USB port
of your PC.
7. The message "New hardware found" appears and the HID driver is
installed automatically.
After installation, click on Start/Settings/Control Panel. Double click on "Game
controllers" ("Gaming Options" under Win Me). In the window that opens, the
racing wheel should be listed with "OK".
Click on Properties to test the racing wheel.
Adjusting the tilt angle
You can adjust the tilt angle of the racing wheel to suit your playing position.
Move the lever at the back to the "Unlock" position and adjust the tilt angle. Lock
it again afterwards.
14