Rechargeable Battery - JB Systems PPA-101 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

ENGLISH
IR-REMOTE
A. PLAY/PAUSE: press to start/pause playback, same as button (5).
B. PREVIOUS/NEXT TRACK: same as buttons (8) and (9)
C. EQ button: used to select one of the EQ presets [Normal, Rock, Pop,
Classic, Country] on the player module. We recommend to always use
the Normal setting!
D. NUMBER keys: you can use these for direct track access while using
the internal MP3-player.
E. [CHANNEL] ± buttons: in tuner mode you can manually search for
radio stations.
F. VOLUME buttons: used to change the output volume of the player
module. We recommend to keep the volume at maximum (vol = 32)
and use the level knob on the mixer instead.
G. [RPT]-button: REPEAT-button, same as button (7)
H. [MODE]-button: same function as the SOURCE-button (4)
 Press the [SOURCE]-button (4) until the display shows the [BLUETOOTH
 The display (3) shows ["Not Connected !"]
 Activate the [Bluetooth] function on your smartphone/tablet and search for [Bluetooth] devices.
 The PPA-101 will show up with the name ["Bluetooth"]:
 Connect to the PPA-101: the display (3) on the PPA-101 will show ["Connected !"]
 Ready for use !

RECHARGEABLE BATTERY

The PPA-101 can work using an optional rechargeable lead/acid battery. This lead/acid battery can be
ordered separately from JB Systems or you can buy it from your local store.
BATTERY SIZE / CAPACITY: (LxWxH) 150x65x95mm ~ 12Vdc / 7Ah
INSTALLING THE BATTERY
 Make sure that the PPA-101 is not connected to the mains.
 Open the storage compartment (37): on the back you will see a
plastic panel.
 Remove the 6 screws (K) and remove the plastic panel.
 Inside you will see 2 wires: 1 black wire + 1red wire.
 Install the lead/acid battery in the compartment with the 2 contacts
facing to the right.
 Connect the RED wire to the RED-contact (sometime marked "+")
on the battery (L).
 Connect the BLACK wire to the BLACK-contact (sometime marked
"-") on the battery (L).
 Put the plastic panel with its 6 screws back in place.
 Close the storage compartment
 Put the battery switch (23) in the ON-position
 Connect the PPA-101 to the mains to charge the battery: the [CHARGE]-indicator (24) is lit.
 When the [FULL]-indicator (25) is lit, the battery is full and ready to be used.
VERY IMPORTANT:
To extend the lifetime of the battery it is very important to NEVER store the unit with an empty
battery! So keep in mind to ALWAYS store the unit with a fully charged battery. If the unit is stored
for a long time, recharge it every 3 months! NO guarantee is offered on the rechargeable battery!
RECHARGING THE BATTERY:
 Put the battery switch (23) in the ON-position
 Connect the PPA-101 to the mains to charge the battery: the [CHARGE]-indicator (24) is lit.
 When the [FULL]-indicator (25) is lit, the battery is full and ready to be used.
Note: charging goes faster when the power switch (28) is in the OFF-position.
JB SYSTEMS
®
RECHARGING THE BATTERY
6/39
OPERATION MANUAL
®
] logo
PPA-101
-

Publicidad

Tabla de contenido
loading

Tabla de contenido