Publicidad
Idiomas disponibles
Idiomas disponibles
Enlaces rápidos
Stereo
Headphones
MDR-ZX700
©2010 Sony Corporation
Printed in Thailand
Tactile dot
4-193-857-31(1)
Operating Instructions
Manual de instrucciones
Stereo mini plug
English
Stereo headphones
Features
Large 50 mm driver unit reproduces a wide frequency range, broader dynamic range
and accurate sound
360 kJ/m
high power neodymium magnets are used to reproduce clear mid-range
3
sounds and wealthy low range sounds
Resists high power input up to 2,000 mW
Noise isolation earpad with pressure-relieving urethane cushion for a good attenuation
of ambient noise and a comfortable fit
Single-sided cord
How to use
How to wear the headphones (see fig. )
Extend the slider to adjust the length.
Wear the headphone marked on your right ear, and the one marked on your left
ear.
There is a tactile dot on the unit marked to distinguish the left side.
How to connect the headphones (see fig. )
These headphones are for use with a stereo mini jack.
Specifications
Type: Closed, dynamic (circum-aural) / Driver unit: 50 mm, dome type (OFC Voice
Coil) / Power handling capacity: 2,000 mW (IEC*) / Impedance: 24 Ω at 1 kHz /
Sensitivity: 106 dB/mW / Frequency response: 5 – 40,000 Hz / Cord : 1.2 m (47 1/4 in),
Single-sided OFC Litz cord / Plug : Gold-plated stereo mini plug / Mass: Approx. 260 g
(9.17 oz) without cord / Supplied accessory : Operating Instructions (1)
* IEC = International Electrotechnical Commission
Design and specifications are subject to change without notice.
Precautions
Listening with headphones at high volume may affect your hearing. For traffic safety,
do not use while driving or cycling.
Do not subject the headphones to excessive shock.
Handle the driver units carefully.
The earpads may deteriorate due to long-term storage or use.
Do not leave the jack plug dirty otherwise the sound may be distorted.
Clean the headphones with a soft dry cloth. Do not blow on the units when cleaning.
Do not allow the plug to become dirty, otherwise the sound may deteriorate.
Do not leave the stereo headphones in a location subject to direct sunlight, heat or
moisture.
This mark is valid only in those European countries where it is legally
applicable.
Publicidad
Manuales relacionados para Sony MDR-ZX700
Resumen de contenidos para Sony MDR-ZX700
- Página 1 Noise isolation earpad with pressure-relieving urethane cushion for a good attenuation of ambient noise and a comfortable fit Single-sided cord How to use MDR-ZX700 How to wear the headphones (see fig. ) Extend the slider to adjust the length. Wear the headphone marked on your right ear, and the one marked on your left ©2010 Sony Corporation Printed in Thailand ear. There is a tactile dot on the unit marked to distinguish the left side. How to connect the headphones (see fig. ) These headphones are for use with a stereo mini jack. Specifications...
- Página 2 Español Auriculares estéreo Características Punto táctil Las unidades auriculares grandes de 50 mm reproducen un rango de frecuencia amplio, un rango dinámico más ancho y un sonido preciso Los imanes de neodimio de alta potencia de 360 kJ/m son utilizados para reproducir sonidos de rango medio claros y sonidos de rango bajo afluentes Resiste una entrada de alta potencia de hasta 2.000 mW Almohadilla con aislamiento de ruido y almohadilla de uretano con alivio de presión para una buena atenuación de los ruidos ambientales y un ajuste cómodo Cable de un solo lado Utilización Utilización de los auriculares (consulte la fig. ) Extienda el deslizador para ajustar la longitud. Coloque el auricular marcado con en la oreja derecha y el que está marcado con en la izquierda. Hay un punto táctil en la unidad marcada con una para diferenciar el lado izquierdo. Conexión de los auriculares (consulte la fig.