Storage; Troubleshooting - Philips GC5000 serie Manual De Instruccion

EnGlish
16
Problem
The iron is plugged
in, but the soleplate
is cold.
The iron does not
produce any steam.

storage

1 Remove the plug from the wall socket.
2 Empty the water tank and let the iron cool down in a safe place.
3 Wind the mains cord round the heel of the appliance and fix it with
the cord clip. Store the iron on its heel in a safe and dry place.

troubleshooting

This chapter summarises the most common problems you could
encounter with the appliance. If you are unable to solve the problem with
the information below, visit www.philips.com/support for a list of
frequently asked questions or contact the Consumer Care Centre in your
country.
Possible cause
There is a connection problem.
There is not enough water in the
water tank.
The iron is not hot enough to
produce steam.
You did not move the iron.
The iron is not plugged in.
Solution
Check the mains cord, the plug and the
wall socket.
Fill the water tank (see chapter 'Using
the appliance', section 'Filling the water
tank').
Wait until the Smart light has stopped
flashing and lights up continuously.
This iron is equipped with a motion
sensor and starts producing steam as
soon as it is moved.
Plug in the iron to switch it on.