Publicidad
Idiomas disponibles
Idiomas disponibles
Set-Up Procedure
1 .Remove protective film from the control
panel.
2. Remove the front panel by pulling gently
from the lower portion of the panel, Do
not force; the panel should remove easily,
3_Remove the plastic frame from the unit.
4, Remove the True HEPA Filter and re-
move the plastic wrapper from the filter,_
5. Install the True HEPA Filter with the
arrow showing °air flow" pointing in
toward the back of the air cleaner; the
white tabs at the top and bottom of the
HEPA filler will poini out to the front of
the uniL
6_Open the resealable plastic bag con-
taining the Carbon Pre-Filters and
remove one filter. Reseal the plastic
bag to maintain the freshness
of the
remaining filter.
7Anstall the Carbon Pre-Filter onto the
plastic frame by pushing against six
=hook and loop" squares on the back of
the frame. (Diag_ 7A)
8,Install the plastic frame by inserting tabs
_)
up into the air cleaner and gently
pushing in at the bottom tab until the
frame fits into place snuggly,
9.Replace
the front panel by hooking
the panel on the top of the unit, Swing
the panel in by pushing gently on each
side of the unit and then lock it into place.
10. Plug the power cord into a wall outleL
11. Press and hold the POWER
button until
a short =beep" sounds_
12oThe air cleaner will take 3-4 minutes to
calibrate the AIR QUALITY sensor, During
this time the sensor lights will flash on
and off. Once the sensor has calibrated,
the lights will stop flashing and the unit
will begin in AUTO mode.
!3,Remove
tab from remote control
(85450185300
only)_
Note: For best results and to maximize air
flow:
• Place unit at least 2 feet away from the wall
• Place the unit away from drafty areas, as
the sensors may not react accurately,
• Do not place near curtains, furniture,
or
other items that might inhibit air flow_
• Place the unit on a stable surfacer
@
O
7
@
O
O
O
Publicidad
