Velleman PCUSBVC3 Manual Del Usuario página 4

 Click [Finish] to finalize driver installation.
 The system will now ask to restart the computer. Select [Yes, I want to restart my computer now].
 Connect the PCUSBVC3 to your video source (not incl., e.g. TV, camera, DVD...). Note that you must
connect the device to an S-video or Composite/audio output! Refer to the user manual of your video
source to locate signal output connectors.
 Connect the USB-connector of the PCUSBVC3 to a free USB port on your computer. Note: for signal
integrity, it is not recommended to connect through a HUB.
 The system detects the new hardware on the USB port and a message box pops up. Select [No, not this
time] and click [Next >].
 Select [Install software automatically] and click [Next >]. Follow the instructions on the screen.
 A window might pop up stating that the SMI GRABBER Device did not pass Windows logo testing; select
[continue anyway].
 Click [Finish] to complete driver installation.
 If any other components are found, please repeat the above procedure until the [Found new hardware:
Your hardware is installed and configured for use]-window appears.
 Verify whether the drivers are installed correctly. Right click on [My computer] and click left to select
[Properties].
 Go to the [Hardware] tab and select [Device manager].
 Go to the [Sound, video and game controllers].
 Locate the [SMI GRABBER Device]. If no exclamation marks (yellow triangles) are shown in front of the
device names, the installation was successful. Otherwise, remove the driver, disconnect and reconnect the
PCUSBVC3 to re-install the driver.
V. 01 – 07/05/2013
PCUSBVC3
4
[1] not included.
©Velleman nv