Sensotherm TSC5 Instrucciones De Servicio página 10

Operating manual
TSC5
The power unit can be set as Master-, Slave or 0-10Volt-input. The operating mode is
determined via the DIP switch SW1 (20), SW1-1 and SW1-2.
Table, DIP function selection switch SW1 (circuit board)
Operating mode
Master
SW1-1
OFF
SW1-2 ON
X = not considered
The DIP switch may only be positioned in deenergized condition!
ATTENTION
Manual mode
Place the manual- automatic switch (1) in the "MAN" position. With the fan step keys
(4) select the optimal fan speed (faster/ slower). Switch the heating on or off with the
heating on/off key (2).
If no thermostat is connected to the room thermostat input (floating contact) (12) this
input must be bridged with a wire jumper.
If the heating on/off key (2) is used, the power unit activates the heating output (230
VAC) (15) meaning the heating is switched on and the LED display heating (3) lights
up. If the heating on/off key (2) is operated again, the power unit deactivates the heat-
ing output (230 VAC) (15) meaning the heating is switched off and the LED display
heating (3) lapses.
If a room thermostat is connected then the heating output (230 V AC) (15) is switched
on and off by the room thermostat if the heating is switched on via the heating on/off
switch (2). The heating is switched off and the LED display heating (3) flashes if the
room thermostat contact opens.
Automatic mode
Set the optimal fan performance with the fan step keys (4). Subsequently position the
manual-automatic switch (1) on the "AUTO". The fans are switched on and off via the
door contact input (24). If the door is closed, the fans will continue to run for a certain
time (after run time, DIP function selection switch SW1-2 and SW1-3) (11) before they
remain in the "STOP" position. The DIP function selection switch SW1-4 (11) must be
positioned on ON for this. If the switch is positioned on OFF the fans will continue to
run in step 1 if the door is closed. If the door opens again the control will switch from
step 1 to the pre-selected step.
LED display door contact (8) lights up if the door is closed.
10
Slave 0-10V
OFF ON
OFF x
Motors thermo contact
active inactive
SW1-3
ON OFF