To Connect The Water Supply; To Connect Power Tools; To Start The Product; To Start The Product With A Wall Saw Connected - Husqvarna PP 492 Manual Del Usuario

• Set the necessary measurement units. Select the
"SETTINGS" menu and then "SET UNITS".

To connect the water supply

CAUTION: Use only clean water to prevent
that dirt causes a blockage in the water
system.
Note: The water coolant does not stop during a power
failure.
Note: The product has an electric water valve, which is
closed when the product starts. When the product is
disconnected from the current, the water valve opens to
drain the water coolant. This is to prevent the water
inside the product to freeze.
1. Connect the water hose to the water connector inlet
on the product.
2. Connect the water connector outlet on the product to
the power tool.
3. To adjust the flow of water coolant to the power tool,
refer to the operator's manual for the power tool.
4. Refer to Technical data on page 17 for water
pressure.
12

To connect power tools

1. Use the upper connector (A) for the PRIME
products.
A
2. Use the lower connector (B) to connect to wall saws.
3. For more information, refer to
page 17 .

To start the product

1. Open the water supply to the product.
2. Turn the machine stop button on the power pack unit
and on the remote control clockwise to disengage.
3. Press the ON/OFF button to start the remote control.
This also starts the connected power tool,
information is shown on the display. Refer to the
operators manual for the connected power tool for
more information.

To start the product with a wall saw connected

Do the procedure in section
12 before you do this procedure.
B
Technical data on
OK
ON/OFF
0
To start the product on page
967 - 001 - 04.02.2020