Electrical Connections; Operation Instructions - Urrea RP801 Manual De Usuario Y Garantía

4. Make sure bag is secure.
Hose clamp.
Inlet hose.
Reducer.
Bag clamp.
Filter bag.
Fig. 3
CAUTION: Do not permit fingers to touch
terminals of plug when installing or remov-
ing the plug to or from the outlet.
WARNING: Do not connect to power
source until unit is completely assembled.

ELECTRICAL CONNECTIONS

WARNING: All electrical connections must
be performed by a qualified electrician. Make
sure tool is off and disconnected from power
source while motor is mounted, connected,
reconnected or anytime wiring is inspected.
Motor and wires are installed as shown in
wiring diagram. Motor is assembled with
approved, 3-conductor cord to be used at
120/220 volts. Motor is prewired at the fac-
tory for 115 volts.
Nozzle.
Blower housing.
90˚ Elbow.
E N G L I S H •
To use the dust collectors with a 220 V power
supply, have a qualified electrician rewire
motor and attach a 220 volt, 15 A three-
prong plug onto dust collector line cord.
WARNING: Wiring should be performed
by a qualified electrician.
GROUNDING INSTRUCTIONS
WARNING: Improper
equipment grounding conductor can result
in risk of electrical shock. Equipment should
be grounded while in use to protect opera-
tor from electrical shock.
Inspect tool cords periodically, and, if dam-
aged, have them repaired by an authorized
service facility.
Green (or green and yellow) conductor in
the cord is the grounding wire. Never con-
nect the green (or green and yellow) wire to
a live terminal. Many cover plate screws, wa-
ter pipes and outlet boxes are not properly
grounded. To ensure a proper ground, the
grounding means must be tested by a quali-
fied electrician.

OPERATION INSTRUCTIONS

OPERATION
CAUTION: Always be sure that the tool is
switched off and unplugged before adjust-
ing or checking function on the tool.
1. Position dust collector near dust producing
machine on a flat level surface.
2. Connect inlet hose to dust producing ma-
chine using hose clamp. Use nozzle if needed.
3. Turn dust collector on before starting dust
producing machine.
EMPTYING FILTER BAG
DANGER: Turn switch off and remove
plug from power source outlet before emp-
tying filter bag.
1. Empty filter bag by loosening clamp. Slide
bag away from housing. Dispose of dust
properly.
2. Mount filter bag by sliding bag over 90°
elbow and tightening clamp. Make sure filter
bag is secure.
U se r's m a n ua l
connection of
13