Features; Charging The Jump Starter - Maxx EverStart SL097 Manual Del Usuario

4.7 For a positive-grounded vehicle, connect the NEGATIVE (BLACK)
clamp from the jump starter to the NEGATIVE (NEG, N, -) ungrounded
post of the battery. Connect the POSITIVE (RED) clamp to the vehicle
chassis or engine block away from the battery. Do not connect the
clamp to the carburetor, fuel lines or sheet-metal body parts. Connect to
a heavy gauge metal part of the frame or engine block.
4.8 When finished using the jump starter, remove the clamp from the vehicle
chassis and then remove the clamp from the battery terminal. Disconnect
the clamps from the unit.

5. FEATURES

1.
Power Level button
2. Power level LEDs
3. Battery clamps with smart cable
4. Jump start output socket
5. USB output port
6. Micro USB Input port
for recharging

6. CHARGING THE JUMP STARTER

IMPORTANT! CHARGE IMMEDIATELY AFTER PURCHASE,
AFTER EACH USE AND EVERY 30 DAYS, OR WHEN THE
CHARGE LEVEL FALLS BELOW 75%, TO KEEP THE INTERNAL
BATTERY FULLY CHARGED AND PROLONG BATTERY LIFE.
6.1 CHECKING THE LEVEL OF THE INTERNAL BATTERY
1. Slide the ON/OFF switch to the ON position. Press the
button on the front of the unit. The number of LEDs lit indicates
the charge level:
● ● ● ● 100% charged
● ● ● 75% charged
● ● 50% charged
● 25% charged
Charge the internal battery if the LEDs indicate less than 75%.
1
2
3
• 7 •
4
5
7. ON/OFF switch
Not shown:
8. LED light (on back)
9. Micro USB-USB
charging cable
10. Carrying bag
7
6
Power Level