Location And Function Of Parts And Controls; Front Panel - Olympus OEV143 Instrucciones De Uso

Location and Function of Parts and Controls

Front Panel

LINE RGB/COMPONENT
A B A
RESET
DEGAUSS UNDER
SCAN
1 Tally indicator
This indicator lights up. When tally control connection is
needed.
For the pin assignment, see "Specifications" on page 22.
2 U POWER switch and indicator
Depress to turn the monitor on. The indicator will light
up in green. To turn the power off, press this again.
3 REMOTE indicator
This indicator lights up in the conditions below:
— When PRESET is set to ON or PRESET ADJUST in
the menu.
— When REMOTE (RS-232C) is set to REMOTE
ONLY or REMOTE & LOCAL in the menu, or
— When REMOTE ON is set via the REMOTE 1
terminal.
4 Á VOLUME control
Turn this control clockwise or counterclockwise to
obtain the desired volume.
5 > CONTRAST control
Turn clockwise to make the contrast stronger and
counterclockwise to make it weaker.
6
PHASE control
This control is effective only for the NTSC color
system. Turn clockwise to make the skin tones greenish
and counterclockwise to make them purplish.
6
B SPLIT MENU
APERTURE
E X I T
SELECT
MIN
OVER
ENTER
SCAN
BRIGHT CHROMA PHASE CONTRAST
– + MIN MAX PUR GRN MIN MAX MIN MAX
MAX
7 ¯ CHROMA (chrominance) control
Turn clockwise to make the color intensity stronger and
counterclockwise to make it weaker.
8 ¨ BRIGHT (brightness) control
Turn clockwise for more brightness and
counterclockwise for less.
9 ΠAPERTURE control
Turn clockwise for more sharpness and
counterclockwise for less.
When the control is set to MIN, the picture becomes flat
without need for corrections.
Note
The APERTURE, CHROMA, PHASE control settings
have no effect on the pictures of RGB signals.
The PHASE control setting has no effect on the pictures
of PAL signals and component signals.
!º MENU (EXIT) button
Press to make the menu appear.
Press to return to the previous screen in the menu.
!¡ ENTER (SELECT) button
Press to decide a selected item in the menu.
VOLUME POWER
REMOTE