Air Filter - Sears Craftsman Manual De Uso

Ocultar thumbs Ver también para Craftsman:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

ENGINE
LUBRICATION
Use only high quality detergent oil rated with
API service classification
SF-SJ. Select the
oil's SAE viscosity grade according
to your
expected operating temperature.
SAE VISCOSITY GRADES
I l*lvlv_
I
F
-20
0
30
32
40
60
80
100
c -10
-2o
-1;
;
1;
_0
1o
4;
TEMPERATURE
RANGE ANTICIPATED
BEFORE
NEXT OIL CHANGE
NOTE: Although
multi-viscosity
oils
(5W30, 10W30 etc.)improve
starting in
cold weather, these multi-viscosity
oils will
result in increased oil consumption
when
used above 32°F. Check your engine oil
ieve! more frequently to avoid possible
engine damage from running low on oil.
Change the oi! after every 25 hours of op-
eration orat least once a year if the mower
is not used for 25 hours in one year.
Check the crankcase oil level before
starting the engine and after each five (5)
hours of continuous
use. Tighten oil plug
securely each time you check the oil level.
TO CHANGE ENGINE OIL
NOTE:
Before tipping lawn mower to drain
oil, empty fuel tank by running engine until
fuel tank is empty.
1. Disconnect
spark plug wire from spark
plug and place wire where it cannot
come in contact with plug.
2. Remove engine oil cap; lay aside on a
clean surface.
3. Tip lawn mower on its side as shown
and drain oil into a suitable container.
Rock lawn mower back and forth to re-
move any oil trapped inside of engine.
6. Stop adding oil when you reach the
FULL mark on the dipstick.
Wait a
minute to allow oil to settle.
7. Continue adding small amounts of oil,
rechecking
the dipstick until oil level
settles at FULL.
DO NOT overfill, or
engine will smoke heavily from the
muffler on startup.
8. Always be sure to retighten oil dipstick
before starting engine.
9. Reconnect spark plug wire to spark plug.
AIR FILTER
Your engine wil! not run properly using a dirty
air filter. Replace paper cartridge every 100
hours of operation or every season, which-
ever occurs first. Service air cleaner more
often under dusty conditions.
1. Loosen screws and remove cover.
2. Carefully remove cartridge.
3. Clean by gently tapping on a flat sur-
face. If very dirty, replace cartridge.
£kCAUTION:
Petroleum solvents, such
as kerosene, are not to be used to clean
cartridge. They may cause deterioration
of the cartridge. Do not oil cartridge. Do
not use pressurized
air to clean or dry
cartridge.
4. Install cartridge, then replace cover.
i
Base
Container
4. Wipe off any spilled oil from lawn
mower or side of engine.
5. Slowly pour oil down the oil fill spout,
stopping every few ounces to check the
oil level with the dipstick.
MUFFLER
Inspect and replace corroded
muffler as it
could create a fire hazard and/or damage.
SPARK
PLUG
Replace spark plug at the beginning of
each mowing season or after every 100
hours of operation, whichever
occurs
first. Spark plug type and gap setting
are shown in the "PRODUCT
SPECIFIC-
ATIONS" section of this manual.
14

Publicidad

Tabla de contenido
loading

Tabla de contenido