Sears Craftsman 917.294270 Manual De Uso página 21

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

TROUBLESHOOTING
CHART:
See appropriate section in manual unless directed to Sears service center
PROBLEM
Will not start
Hard to start
Loss of power
CAUSE
1. Out of fuel.
2. Engine not"CHOKED"
properly.
3. Engine flooded.
4. Dirty air cleaner.
5. Water in fuel.
6. Clogged fuet tank.
7. Loose spark plug wire.
8. Bad spark plug or
improper gap.
9. Carburetor out of adjust-
ment.
1. Throttle control not set
properly.
2. Dirty air cleaner.
3. Bad spark plug or
improper gap.
4. Stale or dirty fuel.
5. Loose spark plug wire.
6. Carburetor out of
adjustment.
1. Engine is overloaded.
2. Dirty air cleaner.
3. Low oil level/dirty oil.
4. Faulty spark plug.
5. Oil in fuel.
6. Stale or dirty fuel.
7. Water in fuel.
8.
Clogged
fuet tank.
9.
Spark
plug
wire loose.
10. Dirty engine air screen.
11. Dirty/clogged
muffler.
12. Carburetor out of
adjustment.
13. Poor compression.
21
CORRECTION
1. Fill fuel tank.
2. See "TO START ENGINE" in
the Operation section.
3. Wait several minutes before
attempting to start.
4. Clean or replace air cleaner
cartridge.
5. Empty fuet tank and carbure-
tor, and refill tank with fresh
gasoline.
6. Remove fuel tank and clean.
7. Make sure spark plug wire is
seat ed properly on plug.
8. Replace spark plug or adjust
gap.
9. Make necessary adjust
ments.
1.
Place throttle
control
in
"FAST"
position.
2.
Clean
or replace
air cleaner
cartridge.
3.
Replace
spark plug or adjust
gap.
4.
Empty fuet tank and refill with
fresh gasoline.
5.
Make sure spark
plug wire is
seated
properly
on plug.
6.
Make necessary
adjust
ments.
1. Set depth
stake for shallower
tilling.
2.
Clean
or replace
air cleaner
cartridge.
3.
Check
oil level/change
oil.
4.
Clean
and regap or change
spark plug.
5.
Empty and clean fuet tank
and refill, and clean carburetor.
6.
Empty fuet tank and refill with
fresh gasoline.
7.
Empty fuet tank and carbure-
tor, and refill tank with fresh
gasoline.
8.
Remove
fuel tank and clean.
9.
Connect
and tighten
spark
ptug wire.
10.Ctean
engine
air screen.
11. Clean/replace
muffler.
12. Make necessary
adjust
ments.
13.Contact
a Sears
or other
qualified
service
center.

Publicidad

Tabla de contenido
loading

Tabla de contenido