Dremel PC10 Instrucciones De Funcionamiento página 16

1600A018W0AA 02-18 PC10.qxp_Layout 1 2/7/18 7:28 AM Page 16
To remove: pull the accessory off the backing
pad. Hold the accessory by the "loop" backing
material and peel away from backing pad (as
shown in figure 3), rather than grabbing the
sponge/microfiber material.
To attach the bristle brush: first remove the
backing pad completely and then attach brush
by aligning the threads of the output shank and
finger tighten the bristle brush in a clockwise di-
rection.
16
Assembly
FIG. 3