1600A018W0AA 02-18 PC10.qxp_Layout 1 2/7/18 7:28 AM Page 8
Charge only Dremel Versa. Other types of cord-
less tools may burst causing personal injury and
damage.
Charge tool in temperatures above +32 de-
grees F (0 degrees C) and below +113 degrees
F (45 degrees C). Store tool in locations where
temperatures will not exceed 120 degrees F
(49 degrees C). This is important to prevent se-
rious damage to the battery cells.
Do not recharge tool in damp or wet environ-
ment. Do not expose charger to rain or snow.
Water entering battery charger may result in elec-
tric shock or fire.
Battery leakage may occur under extreme
usage or temperature conditions. Avoid con-
tact with skin and eyes. The battery liquid is
caustic and could cause chemical burns to tis-
sues. If liquid comes in contact with skin, wash
quickly with soap and water. If the liquid contacts
your eyes, flush them with water for a minimum
of 10 minutes and seek medical attention.
Place charger on flat nonflammable surfaces
and away from flammable materials when
recharging tool. Carpeting and other heat insu-
lating surfaces block proper air circulation which
may cause overheating of the charger and tool. If
smoke or melting of the charger or tool is ob-
served, unplug the charger immediately and do
not use the tool or charger. Contact customer
service immediately.
Make sure cord is located so that it will not be
stepped on, tripped over, or otherwise sub-
jected to damage or stress. Damaged plug and
cord may result in electric shock or fire.
8
Disconnect the charger by pulling the plug
rather than the cord. Do not operate charger
with damaged cord or plug; have them re-
placed immediately. Damaged plug or cord may
result in electric shock or fire.
Do not insert tool in charger if tool housing is
cracked. Using damaged tool may result in elec-
tric shock or fire.
Do not disassemble charger or operate the
charger if it has received a sharp blow, been
dropped or otherwise damaged in anyway. In-
correct reassembly or damage may result in elec-
tric shock or fire.
Before each use, check the battery charger,
cable and plug. If damage is detected, do not
use the battery charger. Never open the bat-
tery charger yourself, take it to a Dremel Fac-
tory Service Center, or qualified serviceman
only using original spare parts. Incorrect re-
assembly may result in electric shock or fire.
Do not use attachments not recommended or
sold by Dremel. Using attachments not recom-
mended may result in electric shock or fire.
Do not store tool in charger. Tool stored in
charger over a long period of time could lead to
battery pack damage and fire.
Unplug charger from outlet before storage, at-
tempting any maintenance or cleaning. Such
preventive safety measures reduce the risk of
electric shock or fire.
Keep the battery charger clean by wiping the
charger housing with a damp cloth. Contami-
nation may result in electric shock or fire.