Before Your First Treatment - SKINERA IPL 100k Instrucciones De Uso

9.1 Before your first treatment

E
Remove all jewellery before each treatment.
You must decide which energy level is right for your skin and the area you want
to treat. The device has 5 levels of energy from 1 (the lowest) to 5 (the highest).
To choose the right energy level, test each treatment area separately (refer to
the skin colour chart at the front of this manual).
1. Press the control button to turn on the device. The level 1 energy level
indicator light will go on.
2. Place the treatment surface (#5 in the diagram) on your skin to deliver
one pulse. If you do not experience abnormal discomfort press the
control button again. This will increase the energy level. Deliver one
pulse on a different spot at energy level 2.
3. Continue testing at increased energy levels. Use the energy levels
indicated on the skin colour chart. If you do not experience any adverse
effects within one hour, you can start your full treatment at that energy
level.
E
Use a lower energy level if you experience any discomfort.
Repeat this test for each part of the body you wish to treat.
You are now ready to use your Skinera™ IPL device.
1. Before treating an area, the skin should be shaved, clean, dry and free
of any powders, antiperspirants or deodorants. Do not wax, pluck or
tweeze the hair out.
2. Press the control button. The device will turn on, the level 1 energy
indicator light will be on, and a fan sound will start.
3. Approximately 1 second after pressing the control button, the ready light
will turn on (#4 in the diagram). The device is then ready to use at the
lowest energy level.
Set the energy level. Press the control button repeatedly to increase
4.
the energy level until you have the level you want. The energy level
indicator lights indicate the energy level setting (refer to section "8.2
Energy levels").
13
EN