Explanation Of Displays And Buttons - Selve i-R Marki WS Manual De Instrucciones

Explanation of displays and buttons

Explanation of displays and buttons
Transmission
control light
Rain sensor
connection
Change-over
switch awnings/
Venetian blinds
Change-over
switch drive con-
trol device/group
control device
Top view
Setting the sun and wind threshold values
The values can be set with the i-R Marki Send WS and the i-R Marki Send Plus.
Please refer to these operating instructions for the setting.
Rain sensor (only i-R Marki WSRF)
The awning automatically retracts when it starts to rain. Automatic extension is
pre vented.
Transmission control light
A radio signal is indicated by the transmission control light being lit.
Change-over switch awning/Venetian blind
(only i-R Marki WS/WSRF/Transmit WS)
The control output of the sensor can be set to awning mode (bottom)/Venetian blind
mode (top) via coding switch 1.
Change-over switch drive control device/group control device
(only i-R Marki WS/ WSRF)
The control output of the sensor can be set to drive control device (bottom)/group
control device (top) via coding switch 2.
UP-/STOP-/DOWN button
Use these buttons to operate the system from the sensor (e.g. testing of the trans-
mission path).
Programming button
Use this button to program the sensor into the receiver. Additional sensors can be
programmed for the i-R Marki WS/WSRF.
19
GB
UP (retraction)/
STOP/
DOWN (extension)
button
Programming
button/PROG
Bottom view