Transmitter Programming Procedure; Sensor As Transmitter; Programming The Sensor; Deprogramming The Sensor - Selve i-R Marki WS Manual De Instrucciones

GB Transmitter programming procedure

Transmitter programming procedure

1.) Sensor as transmitter

1.1) Programming the sensor

Press the PROG button on the receiver or a programmed transmitter for 3 seconds
(wait for confirmation: brief upwards and downwards movement of the motor). The
receiver remains in programming mode for 1 minute. Briefly press (1 sec.) the
PROG button of the sensor. The sensor has now been programmed.
Receiver or
programmed transmitter
3 sec.

1.2) Deprogramming the sensor

Press the PROG button on the receiver or a programmed transmitter for 3 seconds
(wait for confirmation: brief upwards and downwards movement of the motor). The
receiver remains in programming mode for 1 minute. Briefly press (1 sec.) the
PROG button of the sensor. The sensor has now been deprogrammed.
Receiver or
programmed transmitter
3 sec.

2.) Sensor as receiver (only i-R Marki WS/WSRF)

2.1) Programming a transmitter (only i-R Marki WS/WSRF)

Press the PROG button on the sensor for 3 seconds (wait for confirmation: brief
upwards and downwards movement of the motor). The receiver remains in
programming mode for 1 minute. Briefly press (1 sec.) the PROG button of the
transmitter which is to be programmed. The transmitter has now been
programmed.
i-R Marki WS/WSRF
3 sec.
Sensor
➡
Sensor
➡
Transmitter
➡
1 sec.
✓
1 sec.
✓
1 sec.
✓
26