Install Batteries In Wireless Devices - Honeywell RedLINK Serie Manual De Instalación

RedLINK™ Installation Guide (Wireless Accessories)
1

Install batteries in wireless devices

Make sure batteries are inserted properly (see polarity marks on illustrations
below).
Remote control
2
Link devices to wireless network
Press
CONNECT
Flashing status light times out after 15
minutes of inactivity. Press
necessary.
Install 3 fresh AA
batteries
again if
CONNECT
Outdoor air sensor
Press the
CONNECT
wireless adapter and wait for green
flashing light to begin linking devices to
the wireless network (see page 3).
If the light stops flashing before you
have linked all devices, press
again.
If light does not flash, another EIM/wireless
adapter may be in wireless setup mode. Exit
wireless setup at the other EIM/wireless
adapter.
2
Install 2 fresh AA
lithium batteries
button at the EIM or
CONNECT
Continued on next page >>