URSUS TROTTER UT-SILENT1804 Manual De Usuario página 8

Furniture brush
Uholstery nozzle
Floor nozzle settings for carpets and tiled, wood-
block or
similar floors:
A: Hard floors = brush bar extended
B: Carpets = brush bar retracted
Operation
Vacuum cleaning
1:Before using the device first roll out a sufficient
length of electric flex cable and plug into the mains
socket. The yellow mark on the electric flex cable is
the maximum length that must not be exceeded.
To switch on the device press the foot pedal button
on the casing with your foot
2: To rewind the power cable,press the button
with one hand and guide the cable with the
other hand to ensure that it does not whip causing
damage.
How to maintain
The instructions given in this booklet serve as a
guide to routine maintenance. To avoid unnecessary
service calls, check the hose, bag and filter often.
Clear a clogged hose with the blower, change the
bag if it is full, and clean the motor filter when it is
dirty.
Disposable Dust Bags and Filters
The dust bag and motor filter play a very important
roll in the efficiency of the vacuum cleaner. The
purpose of the dust bag is to trap dirt, but at the
same time, the paper bag must be porous enough
to allow air to pass through. If the bag or the motor
filter become clogged, no air can pass through the
cleaner and no cleaning can take place regardless
of how powerful the unit is. To keep the cleaner
operating at maximum efficiency, change the dust
bag frequently and clean the filter as needed. Some
fine particles can restrict airflow very quickly and will
decrease performance even before the bag appears
to be full. For that reason, when vacuuming carpet
fresheners or cleaners, powder, plaster dust, or
similar fine substances, the bag and filter may need
to be changed more often.
How to Remove Dust Bag
NOTE: Turn off vacuum and unplug the electrical
cord before changing dust bag or cleaning motor
filter. Never operate the vacuum cleaner without
the dust bag or filter.
1 . Turn off and unplug cleaner.
2. Open bag cover by pushing latch up with fingers
and lifting bag cover.
3. Locate dust bag frame handle. Raise dust bag out
of dust bag compartment.
Raise dust bag out of dust bag compartment.
4. Remove dust bag from dust bag frame.
Latch