URSUS TROTTER UT-SILENT1804 Manual De Usuario página 9

How to Install Dust Bag
NOTE: Turn off vacuum and unplug the electrical
cord before changing dust bag or cleaning motor
filter. Never operate the vacuum cleaner without
the dust bag or filter.
1. Turn off and unplug cleaner.
2. Open bag cover by pushing latch up with fingers
and lifting bag cover.
3. Remove motor filter and clean by rinsing under
warm water, if heavily soiled. Let completely air dry
before reinstalling.
4. Open bag folds slightly.
5. Place dust bag in dust bag frame by pushing
cardboard collar into ledge
on dust bag frame until collar snaps into position.
6. Place dust bag frame inside dust bag
compartment placing dust bag frame into the
guides at the very front of
the dust bag compartment.
7. Swing bag cover lid closed and push to latch.
Regulating the suction power
You can set the suction power on the device
individually as you require it using the suction
regulator. We recommend using minimum suction
power for delicate materials.
Select medium suction power for mattresses,
upholstered furniture and carpets. Select maximum
suction power for tiled, wood and other robust
floors.
Cleaning the HEPA filter
The HEPA filter and the HEPA cover should be
cleaned regularly. Cleaning is best done when
emptying the dust container. To do this follow the
instructions in the Emptying dust container section.
1. Switch off the vacuum cleaner and disconnect the
plug from the mains. To do this always pull on the
plug and not on the cable.
2. You can pull the dust container together with the
cleaning system out of their anchoring with the aid
of the carrier handle on the dust container. Take
hold of the carrier handle on the dust container and
pull it upwards. Now pull the dust container out and
loosen the HEPA cover and HEPA filter out of the
dust container with the aid of the lateral unlocking
button.
3.Turn the dust container cover carefully until it is
released and the
HEPA filter will come away easily
4. Now rinse the HEPA filter under running water and
allow it to dry.
5. Place the HEPA filter back in the HEPA cover
(or replace with a new one) and fit it into the dust
container.
Then fit the dust container back into position in the
cyclone dust container until it snaps into place. Your
cyclone vacuum cleaner is now ready for use again.
Cleaning the exhaust air filter
The exhaust air filter cleans the air a final time before
it leaves
the vacuum cleaner. You can clean the exhaust air
filter as follows:
1. Switch off the vacuum cleaner and disconnect the
plug from
the mains. To do this always pull on the plug and not
on the cable.
2. Open the exhaust air grill (this is at the rear of the
cyclone vacuum cleaner.)
3. The exhaust air filter is visible when the grill has
been opened.
4. Rinse the filter under cold running water and allow
dry.
5. Put the exhaust air filter back into place (or replace
with a new one) and place in the grill.
6. Close the exhaust air filter grill.