Gladiator GAFZ30FDGB Manual De Uso Y Cuidado página 10

9. Prepare For Foot Pedal
Installation
A
B
Open the product door for easier access to the foot pedal
area. On both sides of the product, loosen the lower
3/8" hex-head bracket screw (B), exposing 1/4" of the
thread, and fully withdraw the upper 3/8" hex-head foot
pedal screw (A).
11. Reinstall The Foot Pedal Bolt
On the door hinge side, use a TORX
3/8" nut driver to feed the screw through the pedal bracket
mounting hole and tighten to the cabinet.
On the non-hinged side, use a TORX
3/8" nut driver to feed the screw through the pedal bracket
mounting hole and two spacers provided, and tighten to the
cabinet.
Helpful Tip: If you are having trouble attaching the two
spacers between the bracket and cabinet, tape the spacer to
the back of the pedal bracket mounting hole with a strip of
transparent tape before adding the screws.
Tighten the second screw with a 3/8" wrench or 3/8" Ratchet
wrench.
10
T25 screwdriver or a
® ®
T25 screwdriver or a
® ®
10. Align And Hang Foot Pedal
Align the circular parts of the foot pedal keyholes with the
lower 3/8" hex-head bracket screws. Hang the pedal on the
lower bracket screws. If the keyhole does not fully engage,
loosen the bolt until engaged.
12. Adjust Actuator Screw If
Desired
Use a Phillips screwdriver to make adjustments to the foot
pedal actuator screw to adjust the foot pedal to your liking.