Reversing The Unit Door - Gladiator GAFZ30FDGB Manual De Uso Y Cuidado

Refer to step 1 and 2 from the "Removing the Unit Door" section.
3. Remove Cabinet Hinge Hole Plugs
A
A. Cabinet Hinge Hole Plugs
Using the putty knife, remove cabinet hinge hole plugs from
the cabinet top and move them to the opposite side hinge
holes. If one breaks, there are replacement parts in your
literature kit.
5. Replace Bottom Hinge
A
A. Bottom Hinge Pin
B. 3/8" Hex-Head Hinge Screws
Replace the four hex head hinge screws on the opposite
3/8"
side, as shown, and tighten the screws.
NOTE: On the reversed door only, switch bottom hinge pin
after the bracket side has been switched.
Using the 5/16" nut driver, switch the bottom hinge pin (A) to
the opposite hole and tighten, as shown.
Reversing the Unit Door (optional)
B
4. Remove Door Hole Plugs
Using the putty knife, remove the door hole plugs from the
door. Place the putty knife in between the black plug and clear
base, and pry outwards, and place the plug in the hole on the
opposite side of the door.
6. Replace Door And Top Hinge
A
B
C
A. Top Hinge Cover
B. 5/16" Hex-Head Hinge Screws
C. Top Hinge
Replace door on bottom hinge pin from previous step.
NOTE: Provide additional support for the door while the
hinges are being moved. Do not depend on the door magnets
to hold the door in place while you are working.
Assemble the parts of the top hinge as shown above. Tighten
the screws completely.
Check all holes to make sure that the hole plugs and screws
are in place. Reinstall the top hinge cover.
B
7