Cleaning with Stain Trapper Tool
WARNING
Keep spray away from face. Failure to do so may result in personal injury.
1
Attach the Stain Trapper tool to the
end of the hose.
3
To empty the Stain Trapper tool, rotate
the small tank on the bottom of the
tool to unlock it.
5
CLEANING THE STAIN TRAPPER TOOL: Clean the front of the tool by
removing the plate over the suction plate. Pull down to remove and rinse with
water. Then replace the plate by sliding back into place.
10
www.BISSELL.com
2
Slowly move the tool back and forth over
the stain. Be careful not to move the tool
back and forth too quickly or soiled water
will flow back into the hose.
4
Dump dirty water into a sink or toilet
and rinse the tank out with clean water.
Replace the tank by lining up the locking teeth
with their mating slots (make sure the two teeth
that are closest together are pointed toward the
brush). Turn the tank to lock it into place.