Bissell SPOTCLEAN LITTLE GREEN 2459 SERIE Guia Del Usuario página 9

Cleaning with Tools
WARNING
Keep spray away from face. Failure to do so may result in personal injury.
CLEANING WITH THE 3"/4" TOUGH STAIN TOOL
CLEANING WITH THE DEEP STAIN/REACH TOOL (select models)
CLEANING WITH THE 3-N-1 STAIR TOOL (select models)
A
B
1 2
FLAT
NOSE
CLEANING WITH THE HYDRORINSE™ TOOL (select models)
NOTE: Ensure that the cleaning solution and water are in the tank before use.
Attach the 3"/4" Tough Stain Tool to the handheld
cleaning hose. Press the spray trigger to mist solution
over and onto the soiled area. Release spray trigger
and gently scrub the stain.
To lift the stain away, apply downward pressure on the
tool and slowly pull it toward you. Then use "drying
strokes" (by not pressing down trigger) to remove
remaining moisture. Repeat as needed.
Attach the Deep Stain/Reach tool to the cleaning hose.
Set the tool directly on top of the carpet before pulling
the spray trigger to inject formula deep into the carpet
fibers.
Always keep the tool in direct contact with carpeting
to avoid over- spraying.
Attach the 3-N-1 tool to the cleaning hose. This
versatile 3-way tool sprays, scrubs and suctions up
C
3
dirt and stains from the outer curves, corner and tread
of a carpeted stairs. Twist the tool head to desired
setting to clean. The downward facing edge is the
active cleaning mode: (a) use the flat area to clean
top of stairs, (b) use pointed edge to clean inside
CREVICE
crevice, (c) use indented area to clean outer corner.
Attach the HyrdoRinse™ tool to the cleaning hose.
Hold the hose and attachment in an upright position.
Then hold down the trigger to rinse the hose for 30
seconds.
The HydroRinse™ tool can be stored on the right
handle or on the hose in between use.
www.BISSELL.com
9