1) Mono And Stereo Mode - Palmer CAB 112 B Manual De Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

1.2.1) MONO AND STEREO MODE

TO RUN THE CABINET IN MONO MODE
Connect the speaker out of your amplifier to the socket marked "Left/
Mono". In this case both speakers are wired in parallel and both will
sound.
Example: If the cabinet is loaded with two 16 Ohms speakers, then the
total impedance at the "Left/Mono" socket will be 8 Ohms.
TO RUN THE CABINET IN STEREO MODE
First connect the socket marked "Right". As soon as a jack connector
is plugged into this socket, the connection between the two speakers
is broken. The cabinet can now be used like two individual 112 cabi-
nets. The signal/amp connected to the "Right" socket will feed the right
speaker and the signal/amp connected to the "Left/mono" socket will feed
the left speaker.
NOTE
Switching between the modes Mono and Stereo is done via a switching jack
socket used for the "Right" input – plugging a jack connector to this
socket will switch the cabinet into stereo mode.
When in Stereo mode, each speaker runs individually. If your cabinet is
loaded with 16 Ohms speakers, then
you will have 2x 16 Ohms inputs.
11

Publicidad

Tabla de contenido
loading

Tabla de contenido